Panasonic DBS 96, Manual

Page: 66 / 159

Section
Installing a in a Single Cabinet
Chapter 4. Trunks and Lines
The following instructions explain how to install a in a single-cabinet
system. These instructions also apply when a is installed in only the
master cabinet of a two cabinet system.
If only one is installed in a two-cabinet system, it must be installed in the
cabinet specified in Table 4-8 on page 13.
Note: The Tl Interface cannot be used for systems consisting of a DBS 72
connected to a DBS 40.
1. Check connector 4 (CN4) on the Sync Unit (VB-43563). Make sure that
Pins 2 and 3 are strapped. (See Figure 4-5.)
When Pins 2 and 3 are strapped, the Sync Unit synchronizes the DBS
card with the signaling provided by the public network.
Figure Connector
S y n c
0
CN3
. . . . . ...*.....
CN4
,
DBS-70-300 DBS Manual Issued
4-21