Panasonic DBS 96, Manual

Page: 57 / 159

Chapter 4. Trunks and Lines Section
Table 4-7. Tl Hardware requirements
for
double-cabinet systems
CPC-B V4
SCC-B
Trunk MDF
Sync
Cable Cable Kit
Location (V-B-43411)
Card Card
Card (VB-43 110)
(See Note
4342 43564)
(See Note
(See Notes
43561) 43562) 43563)
2
and 3.)
in the
1
1 1
1
0
Master
i n t h e
1 1 1 1
1
1
Slave
Notes:
1. Version 1.3 of the Bus Processor Unit chip is required for
2. An MFR card is required for if DTMF signaling is used. If is provided through DP sig-
naling, an MFR card is not required.
3. SCC-B with ROM 1.3 or later is required if the central office does not provide dial tone.
4. Version 1.2 of the is required for
l
The trunk card must be installed in the slot.
l
The installer
must
provide a Channel Service Unit (CSU) that complies
with FCC Part 15 and Part 68. The CSU is installed between the DBS and
the public network. The CSU provides alarm, diagnostic, and monitoring
functions, as well as network protection.
The CSU must be compatible with the framing format (SF or ESF) that is
provided public network.
Maximums
l
One card can be installed per cabinet.
l
The number of Tl cards
that
can be installed in double-cabinet systems
depends on the sizes of the connected systems. Table 4-12 on page 4-15
shows
maximums for double-cabinet systems.
Note: The DBS 72 + DBS 40 combination does not support
4-l 2 Manual Issued