Section
Chapter 4. Trunks and Lines
Installing in a Double Cabinet with the in the Slave
1.
2.
3.
4.
5.
6.
7.
8.
Install the Sync Unit in the master cabinet as described in Steps 1 and 2
under “Installation for a Single
Install a
MDF card in the slave cabinet. (See Step 3 on page 4-23.)
Set Switch 1 on the
card. (See Step 4 on page 4-24.)
Install a
card in the
slot of the slave cabinet.
Connect the Sync Cable from
on the Sync Unit to
on the
card (Figure 4-l 1).
Note:
Part Number VB-43564 is used for the Sync Cable when a
is
installed only in the slave cabinet of two-cabinet system.
At the slave cabinet, connect the cable attached to CN3 on the
MDF
card to CN3 on the
card (Figure 4-10).
Using an RJ48 cable, connect
of the
MDF card to the CSU. (See
Figure 4-9 on page 4-25 for RJ48 pinouts.)
At the slave cabinet, connect the ground cable on the
MDF card as
shown in Figure 4-10 on page 4-26.
DBS Manual Issued
4-27
Summary of Contents for DBS 96
