5
Receiver
Front side
Rear side
Operation Panel
1. Receiver
Receives the signal sent from the remote
controller.
2. Emergency operation button
Indicator lamps
When an error occurs, one of the lamps
flashes. When an indicator lamp is flashing,
refer to “Before Requesting Service”.
3. OPERATION lamp
Lights up when the unit is operating.
4. TIMER lamp
Lights up when the timer is set.
5. STANDBY lamp
• The lamp in the HEAT mode lights up at
the following times: during the startup,
during the thermostat operation, and
during the defrosting.
• The lamp flashes when an error occurs.
6. FILTER lamp
This lamp is for notifying you when the filter
needs to be cleaned.
7. Address switch
Used to set the remote controller
addresses. (Refer to the installation
instructions for details of the address
setting switch.)
Note
• If non-cooling/heating free type is being
used, it will beep twice and the operating
lamp will light up on the display; if the timer
and standby lamps blink alternately, a
con
fl
ict between the heating and cooling
exists, so the unit cannot operate in the
desired mode. (On models that do not have
an Auto function, even if Auto is selected, it
works in the same way.)
• When the local operation is disabled by
centralized control or similar cause, and if
the Start/Stop , Mode
or Temperature
setting button
is pressed, the unit
will beep
fi
ve times and the change will not
be made.
CZ-RWSC3
CZ-RWSD2
CZ-RWSU2N
CZ-RWSU3
CZ-RWST3N
1
5
4
3
2
1
2
5
4
3
1
2
3 4 5
CZ-RWSL2N
1
5
4
3
2
1 2 3 4
1
2
7
3
4
5
6
ADDRESS 1
ADDRESS 2
ADDRESS 3
REM SUB/MAIN
3
4
5
1
2
7
TIMER
OPERATION
STANDBY
1
2
2
3
4
5
3
4
5
CZ-RWSK2 (For wall mounted type indoor unit)
Display
CZ-RWSU3取説̲簡単ガイド.indd 5
CZ-RWSU3取説̲簡単ガイド.indd 5
2016/07/19 11:55:29
2016/07/19 11:55:29
