Panasonic CS-ME12NKE, Technical & Service Manual

Page: 44 / 440

8
REMOTE CONTROLLER
Transmitter
When you press the buttons on the remote controller, the mark
appears in the display to transmit the setting changes to the receiver
in the air conditioner.
Display
Information on the operating conditions is displayed while the remote
controller is switched on. If the unit is turned off, FLAP setting and
FAN SPEED setting are not displayed.
FAN SPEED selector button
: The air conditioner automatically decides the fan speeds.
: High fan speed
: Medium fan speed
: Low fan speed
FLAP button
Press this button either to select the setting of the airflow direction to the
auto. flap in each mode or one of the six possible positions manually or to
select the sweep function which moves the flap up and down
automatically.
: Auto flap setting: If selected in a heating operation, the flap is set
to position (3) in the following chart. If selected in a cooling or dry
operation, the flap is set at position (7) in the following chart.
: The airflow direction can be set manually. (six positions)
: The flap moves up and down automatically.
When you press the FLAP button, the air flow direction will be changed
one by one as follows.
NOTE
SWEEP
CANCEL button
SENSOR button
When you press this button (use a small-tipped object such as a ballpoint
pen), the mark will appear at the display. And the room temperature is
detected by the sensor which is built into the indoor unit and the air
conditioner is controlled accordingly.
If the remote controller is located near a heat source, such as a space heater
or in direct sunlight, press the SENSOR button to switch to the sensor on the
indoor unit.
NOTE
ADDRESS switch
• The address switch changes to prevent mixing of signals from remote
controllers when two air conditioners are installed next to each other.
Normally, the address switch is set to A. For more information, please
contact the dealer where you made the purchase.
• Normally, the tabs on the remote controller should not be bent.
Temperature display selector button
This switches the temperature display
between °C and °F.
ON TIME/OFF TIME setting buttons
Advance button
Return button
No display: The timer does not operate.
: The air conditioner starts at the set time.
: The air conditioner stops at the set time.
: The air conditioner stops and starts, or starts and
stops, at the set times every day. For details, see
“SETTING THE TIMER”.
QUIET button
: When you press this button, the fan rotates slower than the
fan speed setting to provide a quieter operating sound.
01_85264181223000_EN.fm Page 8 Friday, January 27, 2012 10:15 AM