Panasonic CS-ME12NKE, Technical & Service Manual

Page: 313 / 440

17
English
1HR.
T I MER
ON/OFF
operation
ACL
(Reset)
QU I ET
button
button
button
button
Fig. 59a
Fig. 59b
TIM E R lamp
OP E RATION lamp
Fig. 59c
4. How to Test Run the Air Conditioner
�
For indoor unit types
After turning on the power of the air conditioner, use the remote
controller and follow the steps below to conduct the test run.
(1) Set the remote controller in Test Run mode. (Fig. 59a)
a)Press and hold the QUIET button and the 1HR. TIMER button.
E7KHQSUHVVDQGKROGWKH$&/5HVHWEXWWRQZLWKDSRLQWHG
object such as the tip of a pen. After 5 seconds, release the
$&/EXWWRQILUVW
c)Then release the QUIET and 1HR. TIMER buttons.
d)
appears and “oP-1” blinking in the remote controller clock
display area. (Fig. 59b)
(2) Start Cooling mode test run by pressing the ON/OFF operation
button of the remote controller. (Fig. 59a)
‡ 7KLVVWDUWVWKHIDQSURGXFLQJXQFRROHGIRUFHGDLUZLWKWKHLQGL
cator lamps (OPERATION lamp, TIMER lamp, and ) on the
main unit blinking. (Fig. 59c)
‡ $IWHUPLQXWHVWKHV\VWHPVKLIWVLQWRFRROLQJRSHUDWLRQDQG
cool air will start to be felt. Cooling mode test run is unaffected
by the room temperature.
(3) Press the ON/OFF operation button of the remote controller again
to stop the test run. (Fig. 59a)
)LQDOO\SUHVVWKH$&/5HVHWEXWWRQRIWKHUHPRWHFRQWUROOHUWR
release it from Test Run mode to return to normal mode.
(Fig. 59a)
‡ ´ µDQG´R3µZLOOGLVDSSHDUIURPWKHUHPRWHFRQWUROOHUFORFN
display area.
$IWHUWKHWHVWUXQLVFRPSOHWHGEHVXUHWRSUHVVWKH$&/5HVHW
button to return to normal mode. The air conditioner will not operate
correctly if this is not done.
IMPORTANT
12-295 CU-5E34NBE_IU EN_3.qxd 2/27/12 4:35 PM Page 17