Follow the procedure below to install the software
Do NOT follow the procedure described in “Installing the Software” contained in the Operating
Instructions which accompany the FMV PACK since these steps will not properly install the
software.
Installing the Software
Install the FDD Pack in the Multimedia Pocket.
Turn on the power. (Windows starts up automatically.)
Insert the disk labeled "FMV PACK Setup Disk" into the floppy disk drive.
Click the [Start]-[Run], and then type as shown below inside the frame and click [OK].
Open: c:\util\avapp\fmv61a
Follow the on-screen instructions.
640
X
480
800
X
600
1024
X
768
A d d e n d u m
Notice to users planning to use the FMV PACK (CF-VEV611)
with the CF-61KXF4BAM or CF-61KXF4BAE
NOTE
The message shown on the right may appear while the instal-
lation is in progress or when the computer has been rebooted.
Click “Don’t ask the question again,” add the check mark( ),
and select “No.”
To play MPEG data, select [Start] - [Program] - [Accessories] - [Multimedia] - [Media
Player], select “Real Magic...” from the “Device” menu, and designate the file.
If an attempt is made to play the MPEG data directly by double-clicking the MPEG file in
My Computer or Explorer, etc., the data will be played not by the FMV PACK but by the
Windows standard “ActiveMovie” instead.
Using the settings listed below to play the MPEG data makes it pos-
sible for this computer to produce even smoother pictures.
256 color
High Color (16 bit)
True Color
Supported
Supported
Supported
Supported
Supported
Supported
Supported
In the Internal LCD or Simultaneous (Internal LCD and External CRT) display mode:
The MPEG data can be played but
smooth pictures will not be produced.
640
X
480
800
X
600
1024
X
768
256 color
High Color (16 bit)
True Color
Supported*
Supported*
Supported*
Supported**
Supported**
Supported**
Supported**
The MPEG data can be played but
smooth pictures will not be produced.
* Provided that the refresh rate is less than 75 Hz.
** Provided that the refresh rate is less than 60 Hz.
The refresh rate is set as follows:
[Start] - [Settings] - [Control Panel] - [Display] - [Settings] - [Advanced Properties] - [Adapter].
It may not be possible to set some refresh rate values depending on the display which is used.
Printed in Japan
DFQX1257ZA-1
In the External CRT display mode:
Summary of Contents for CF-61 Series
Page 45: ...45 ...
