22
3. Insert the hard disk, and attach it with screws (in four
places).
The assembly diagram shown below is intended as
an example. The actual connection locations may
differ depending on the model of computer used.
When installing another hard disk unit, remove the
expansion bay brackets, insert the hard disk, and
then secure it in place with screws. then secure it in
place with screws (in four places). (Refer to the dia-
gram below).
The assembly diagram shown below is intended as
an example. The actual connection locations may
differ depending on the model of computer used.
4. Use the flat cable (68-pin, Wide-SCSI) provided with
the SCSI board. Connect one end to the connector
on the hard disk, and connect the other end to the
connector on the SCSI board. (Refer to the diagram
below)
The assembly diagram shown below is intended as
an example. The actual connection locations may
differ depending on the model of computer used.
•When there is only one hard disk, connect to the A
channel connector on the SCSI board.
•When there are two hard disks, connect one to the
A channel connector on the SCSI board, and one to
the B channel connector. Be sure to connect the
power supply connector.
Flat cable
Channel A
Channel B
Hard disk
SCSI board
Screws
Insert into lower bay
Summary of Contents for AY-RP500
Page 57: ...55 ...
