20
Operation
$
Turning on the power
1. Set all the power switches of the connected components
and the power switch of the AC adapter to ON.
2. Set the DC POWER switch on the main unit to ON.
3. Set the OPERATE switch of the control panel to ON.
Power is now supplied to the pan-tilt head systems
connected to the main unit, and the camera’s initial
settings are performed in sequence.
<Notes>
O
At the same time as the camera’s initial settings are
performed, the control panel’s PAN/TILT lever and
ZOOM lever settings are performed as well. Do not
touch the levers while the display below appears on
the LCD panel.
O
It takes about 30 seconds to perform the camera’s
initial settings for each camera. The pan-tilt head
system cannot be controlled until these settings are
completed.
O
All the power switches of the connected components
and the power switch of the AC adapter must be set
to ON without fail before setting the OPERATE switch
of the control panel to ON.
2 2 2
I
IN
NI
IT
TI
IA
AL
LI
IZ
ZE
E
2 2 2
P
PL
LE
EA
AS
SE
E
W
WA
AI
IT
T
$
Setting the travel range (limiters) of the
pan-tilt head
Depending on where it has been installed, there may be
obstacles within the travel range of the pan-tilt head system
with which the system may come into contact.
The pan-tilt head system may malfunction or an accident
may occur if the system comes into contact with such an
obstacle.
Prior to use, be absolutely sure to set the travel range
(limiters: upper, lower, left-most and right-most limits of
rotation) of the pan-tilt head system.
<Note>
Before installing a pan-tilt head as a stand-alone type, set
the installation direction switch inside the pan-tilt head to
stand-alone installation. (“Suspended installation” is the
factory setting.)
If this switch is not set properly, the operating directions of
the pan-tilt head will be reversed, and the limits of the pan-
tilt head’s travel range (limiters) will not be stored in the
memory properly. For details on how to set the switch, refer
to the operating instructions of the pan-tilt head.
1. Select the pan-tilt head system using the
CONTROL/PREVIEW MONITOR OUT SEL button.
2. Set the upper limit position in the travel range.
1
Operate the PAN/TILT lever on the control panel to
rotate the camera to the position which is to serve as
the upper limit position.
2
While holding down the OK button on the control
panel, press TRACING/PRESET MEMORY button
47 .
3
The setting is completed when the 41 [LIMIT ON]
button’s lamp comes on.
O
To cancel the setting, press button 47
while
pressing the OK button again. When the setting is
canceled, the 50 [LIMIT OFF] button’s lamp comes
on.
3. Set the lower limit position in the travel range.
1
Operate the PAN/TILT lever on the control panel to
rotate the camera to the position which is to serve as
the lower limit position.
2
While holding down the OK button, press button 46 .
3
The setting is completed when the 41 [LIMIT ON]
button’s lamp comes on.
O
To cancel the setting, press button 46
while
pressing the OK button again. When the setting is
canceled, the 50 [LIMIT OFF] button’s lamp comes
on.
Summary of Contents for AWPS505 - AC ADAPTOR
Page 45: ......
Page 91: ......
Page 92: ...Panasonic Canada Inc 5770 Ambler Drive Mississauga Ontario L4W 2T3 905 624 5010 ...
