Panasonic AW-HR140, Operating Instruction

Page: 19 / 124

z „
Basic operations of the AW-RP50
For detailed operations, refer to the Operating Instructions of the AW-RP50 — <Operations and Settings>.
POWER ALARM F1 CAMERA
OSD
R/B GAIN R/B PED
SYSTEM SETUP CAMERA SCENE/MODE DETAIL DELETE STORE
PAGE MENU F2 EXIT
USER2 USER1
PT ACTIVE AUTO IRIS
AUTO
HI LOW
PTZ/FOCUS SPEED PAN/TILT FOCUS/
PUSH
OTAF
TELE
ZOOM
WIDE
CAMERA STATUS / SELECTION
PRESET MEMORY / MENU
GAIN/PED
F2
F1
1 2 3
AWB/ABB
4
SHUTTER
5
1 2 3 4 5
6 7 8 9 10
2 6
3
5
4
1, 7
1.
Turn on the AW-RP50’s power.
Set the POWER switch to the ON position.
Power is now supplied to the AW-RP50, and the POWER indicator
lights.
p p
However, when [CAMERA]
>
[POWER]
>
AUTO ON item
have been selected and “On” is selected as the AUTO ON item
setting, power-on is automatically instructed for the remote
cameras controlled by the [SYSTEM]
>
CAM IP ADR item.
2.
Select the remote cameras.
Select the remote cameras to be controlled using the CAMERA
STATUS/SELECTION buttons.
3.
Adjust the direction in which the remote cameras are to
be pointed.
Use the PAN/TILT lever to adjust the direction in which the remote
cameras are to be pointed.
4.
Adjust the zoom.
Use the ZOOM button to adjust the lens zoom.
When the TELE side is pressed, the zoom is set to the telephoto
mode; when the WIDE side is pressed, it is set to the wide-angle
mode.
5.
Adjust the lens iris.
Use the IRIS dial to adjust the lens iris.
p p
While the lens iris is being adjusted, a level meter is displayed
on the LCD panel. (What is displayed by the level meter is an
approximate value.)
IRIS
--

---+------
When performing adjustments for one remote camera from a
multiple number of AW-RP50 remote camera controllers, the
level meter may not show the correct displays.
<NOTE>
6.
Adjust the focus.
Turn the FOCUS/PUSH OTAF dial, and adjust the lens focus.
When the dial is pressed during manual focusing, the auto focus
mode is established temporarily, and the subject is brought into
focus automatically.
p p
The OTAF (one-touch auto focus) takes effect for remote
cameras which are equipped with the OTAF function.
7.
Turn off the AW-RP50’s power.
Set the POWER switch to the OFF position.
The AW-RP50’s power is turned off, and the POWER indicator
goes off.
p p
Even when the AW-RP50’s power is turned off, the power of the
connected remote cameras does not go off.
18 19
AW-RP50 (not supplied) (continued)