Panasonic AU-V35LT1G, Operating Manual

Page: 204 / 214

– 204 –
Chapter 12 Maintenance — Warning system
Display Description Behavior and cause
[CANNOT REPAIR!] Content that cannot be repaired is selected. Check the selected content.
[CANNOT SAVE! FILE NAME IN USE]
A settings file of the same name exists on the SD
memory card.
Use another name to save the file.
[CARD FULL!] The P2 card or SD memory card is full. Insert a card with free space available.
[INVALID VALUE!] The data value you entered is invalid. Enter data within the normal range.
[MISSING CLIP!]
Shot marks cannot be attached to the clips unless all
clips recorded over multiple P2 cards are present.
The camera cannot handle a clip recorded over multiple
cards.
[NO CARD!] No P2 or SD memory card is inserted. Insert the relevant media.
[NO FILE!] The specified file does not exist. Check the file.
[NO INPUT!] No data is entered. Enter data and then set.
[NO SD CARD!] No SD memory card. Insert an SD memory card.
[UNKNOWN CONTENTS FORMAT!]
This is a warning of the contents for the version that is
not supported by the camera.
Match the device and content versions.
[UNKNOWN DATA!]
The metadata character code is invalid.
The metadata character code is UTF-8. Enter valid
characters using a viewer.
There is a problem with data in the file. Create the file again.
[USER CLIP NAME MODIFIED!]
When adding a counter value to the clip name,
characters must be deleted.
For the counter addition setting, the user clip name plus
the counter value can only contain up to 100 bytes.
Characters in the clip name are automatically deleted
when the total number of characters exceeds this limit.
[WRITE PROTECTED!] The P2 card or SD memory card is write-protected. Insert write-accessible media.
During soft keyboard operation
Display Description Behavior and cause
[CANNOT SET!]
[INVALID VALUE!]
The entered value is invalid. Change the input value.
[CANNOT SET!]
[NO INPUT!]
There is not input to the software keyboard. Enter the password.
[CANNOT SET!]
[RETRY PASSWORD IS DIFFERENT!]
The re-entered password is different. Enter the correct reference password.
Network
Message Description Measure
[CANNOT CONNECT!] A connection to the network cannot be established.
Check that the LAN settings are correct. Make sure that
the LAN cable is connected correctly and the network
you use is running.
[CANNOT FIND FTP-SERVER!] The connection destination FTP server cannot be found. Check that [MENU]
→ [SERVER URL] → [FTP CLIENT
SERVICE] → [SERVER URL] is correct.
[LOGIN FAILED!]
Logging in to the connection destination FTP server
failed.
Check that [MENU] → [PERIPHERAL] → [FTP CLIENT
SERVICE] → [LOGIN USER] and [LOGIN PASSWORD]
are correct.
[PING FAILED!] The [PING] failed.
Check that the LAN setting and [MENU] →
[PERIPHERAL] → [FTP CLIENT SERVICE] →
[SERVER URL] are correct. Check that the LAN cable is
connected correctly or the network is operating.
[CANNOT ACCESS GATEWAY!] The gateway server cannot be accessed. Check that the LAN settings are correct.
[CHECK LAN SETTING] The gateway server cannot be accessed. Check that the LAN settings are correct.
[IP ADDRESS IS USED!] The set IP address is being used by another device.
Consult your network administrator and set another IP
address.
[INVALID VALUE!] The entered data value is invalid. Enter data in a valid range.