- 17 -
Configuration example 4: Controlling the camera from the
AW-RP655 or AW-RP555 controller
When installing the camera on the AW-PH650 outdoor pan/tilt head, refer to the operating instructions
of the AW-PH650.
When placing the camera on the AW-PH650 and controlling it from the AW-RP655 or AW-RP555
controller, select “” as the PROTOCOL setting of the AK-HC1800N, and set the camera control
selector switch inside the housing of the AW-PH650 to “CB00.”
When using G/L signals, select “DSUB” as the GEN-LOCK INPUT setting of the AK-HC1800N.
Be absolutely sure to perform and check these settings prior to installation.
To be locally
purchased
Controller
AW-RP655 or
AW-RP555
Monitor
POWER
SDI
OUT
RJ-45 relay adapter
10BASE-T (UTP
category 5) straight
cable
MULTI
AC adapter
AW-PS510AN
G/L input
Outdoor
pan/tilt
head
AW-PH650
Monitor
AK-HC1800N
When mounting the camera on the pan/tilt head:
Select “4” as the PROTOCOL setting.
Select “DSUB” as the GEN-LOCK INPUT setting.
AK-HC1800N
When connecting this unit
directly to the controller:
Select “3” as the PROTOCOL setting.
Set GEN-LOCK INPUT as required.
AC adapter
AW-PS510AN
AW-PH650
Set the camera control
selector switch inside the
housing to “CB400”.
When the AK-HC1800N, to which the motor drive lens is connected, has been
directly connected to the AW-RP655 or AW-RP555 controller, zooming and
focusing can be controlled using the controller’s joystick.
How to set up the system
