Panasonic AG527DVDE - DVD/VCR/MONITOR, Service Manual

Page: 2 / 303

2002 Matsushita Kotobuki Electronics Industries LTD. All rights
reserved. Unauthorized copying and distribution is a violation of
law.
1. SAFETY PRECAUTIONS
1.1. GENERAL GUIDELINES
1. IMPORTANT SAFETY NOTICE
There are special components used in this equipment which are
important for safety. These parts are marked by in the
Schematic Diagrams, Circuit Board Layout, Exploded Views and
Replacement Parts List. It is essential thatthese critical parts
should be replaced with manufacturer’s specified parts to prevent
X-RADIATION, shock, fire, or other hazards. Do not modify the
original design without permission of manufacturer.
2. An Isolation Transformer should always be used during the
servicing of Combination DVD VCR whose chassis is not isolated
from the AC power line. Use a transformer of adequate power
rating as this protects the technician from accidents resultingin
personal injury from electrical shocks. It will also protect
Combination DVD VCR from being damaged by accidental
shorting that may occur during servicing.
3. When servicing, observe the original lead dress, especially the
lead dress in the high voltage circuits. If a short circuit is found,
replace all parts which have been overheated or damaged by the
short circuit.
4. After servicing, see to it that all the protective devices such as
insulation barriers, insulation papers, shield, and isolation R-C
combinations are properly installed.
5. Before turning the receiver on, measure the resistance between B+
line and chassis ground. Connect (-) side of an ohmmeter to the B
2