Panasonic A230, User Manual

Page: 290 / 377

Communications (Serial and Parallel) OCR Type A230
16 − 14
16.2 Communication Settings
4413.Numerical Calculation
Select whether or not to output the results of numerical calculation in the
case that When handshaking is being performed.
If you want to output numerical calculation data, select 8 − bit, 16 − bit, or
32 − bit as the output data length from the Numerical Calculation menu.
Refer to 13.3 Numerical Calculation for details.
4414.Judgment
Select whether or not to output judgment results in the case that When
handshaking is being performed.
Note
If you will use handshaking, it is not possible to set both “4413.
Numerical Calc.” and “4414. Output” for no output. One of the
two must be set for output.
442. Reset Cond.
Select one of the following three methods for resetting the parallel
output data.
Latch (factory setting): Hold until output of the next inspection result.
Off after image capture: Reset (switch off) after completion of the next
inspection image capture.
Off before image capture: Reset (OFF) before starting the next
inspection image capture (after detecting the
start signal).
For a detailed timing chart, refer to Data Switching Timing
(page 16 − 27) .
443. Setting Template
Set whether or not to re − register the Smart Matching template using
parallel input, and select one of the following four execution methods.
No: Do not re − register, even if the re − register
signal is input.
Setting position: Execute re − registration at the position that
the template area was set.
Execution position: Execute the matching checker, and
re − register at the detected position
(or the position with the highest correlation in
the case that multiple objects are detected).
Adjustment position: Execute the Position Adjustment checker, and
perform re − registration at the position where the
template area was first set within the corrected
search area.
Refer to 16.8 Template (Smart Matching) Re − registration for details.