28
29
GB
5
When the machine is searching for the docking
station, if you press CHARGE on the control panel or
the POWER button (indicated in red) and CHARGE on
the remote control, the machine will stop searching
for the docking station. (See figure 6).
6.
When the battery is empty, the indicator will flash.
When the indicator lights up, this means the battery
is fully charged. (See figure 7).
7.
When you start the machine, a flashing power
indicator means the battery level is low and the
battery needs to be charged. (See figure 8).
figure 5
figure 6
figure 7
figure 8
1. The robotic vacuum may not locate the docking station if there is an obstruction,
the battery is low or in more complex situations. The docking station should
therefore be placed in a wide open space, where possible.
2. When the robot finishes cleaning, the battery will be very hot, meaning longer
charging times
4.4. Installing/dismantling and cleaning the container
Installation and dismantling
1.
Remove the container by pressing
the button on the top. (See figures
1 and 2).
2.
Press the red button on the top and
the fan will pop out automatically.
(See figure 3).
3.
Turn the fan around, release the
two catches and open the cover for
cleaning. (See figures 4 and 5).
4.
Pull the tab on the right hand
side towards you and the filter will
appear. (See figure 6).
5.
Clean the filter or insert a new one,
press the semicircular bracket with
one hand to release the filter mesh
clips and remove the grill with the
other hand to clean it or to replace
it. (See figure 7).
6.
Turn the container back around; to
remove the mop, release the right
and left clips on the bottom of the
container (See figures 8 and 9). All
parts must be replaced following
the dismantling steps in reverse
order.
Do not use the mop or pull bar on rugs or uneven floors.
figure 1
figure 2
figure 3
figure 4
figure 5
figure 6
figure 7
figure 8
figure 9
