Robotic Cleaner
Model No.
DRC200
CAUTION
Observe the following to prevent the Robotic Cleaner from falling.
• Remove any dirt and wipe away any condensation or other moisture that has adhered to the cliff
sensors.
• In locations where the Robotic Cleaner may fall and cause an accident or other hazard, place
objects that are 15 cm (5-7/8") in height or taller and can withstand the impact of the Robotic
Cleaner without moving or tipping over to serve as barriers.
• Do not use the Robotic Cleaner in unenclosed high locations such as mezzanines, lofts, or
fl oors with a direct drop onto stairwells or entranceways, or in locations with an incline of 10° or
more.
CAUTION
Observe the following when using the boundary-sensing feature.
• Remove any dirt and wipe away any condensation or other moisture that has adhered to the
boundary sensors located on the bottom of the Robotic Cleaner.
Buttons/indicators on the cleaner
Buttons on the remote control
Troubleshooting lamp
Filter maintenance
lamp
Brush maintenance
lamp
Right battery
indicator
Boundary sensor
button
Vacuum button
Buzzer button
Pilot lamp
Left battery indicator
Timer button
Cruise mode button
POWER (start/stop) button
Pattern mode
button
Vacuum button
Buzzer button
POWER OFF button
Start/Stop button
Location beacon
button
Random mode button
Timer button
Turning the cleaner ON/OFF
Remote control
Cleaner
Cleaner
Turning ON
Turning OFF
Standby mode
Press
Press and
hold for 2 sec.
or more
All indicators
on the
cleaner turn
OFF.
Battery indicator lights up
and indicates the remaining
battery power and the pilot
lamp turns off.
Installing the side brushes
Turning the vacuum fan ON/OFF
1. Position the side brush with the groove of the brush fi tted to
the shaft head.
2. Secure the side brush using the supplied screw.
Shaft head
Groove of the side
brush
Be sure to perform the following procedure in standby mode.
or
The lamp lights up
when the vacuum fan
is turned ON.
Remote control
Cleaner
If you remove most visible dust, turning OFF the vacuum fan will
save the battery power to extend the operating time of the cleaner.
Locations of the
four cliff sensors
(
circled)
Locations of the two
boundary sensors
Quick Start Guide
ENGLISH