27
Venting System Inspection
The venting system should be inspected
annually to ensure all of the vent sections
are secure and air-tight.
It is recommended that qualified service
personnel familiar with Category III
venting inspect the venting system.
Check vent connection joint sections with
a solution of soapy water to assure air-
tightness while the unit is operating.
Bubbles around a joint connection
indicates a seal leak. Refer to page 12 for
vent sealing instructions.
DO NOT
operate the unit if vent system
shows signs of leaking exhaust.
Check to make sure that the Air Intake and
the vent terminal have not been blocked or
contain debris.
Burner Inspection
Visually inspect the main burners
annually.
Through the sight glass, inspect the burner
flame with the main burner off and inspect
the main burner while firing.
If any unusual burner operation is noted,
the water heater should be shut off until
qualified service assistance can be
obtained.
CAUTION: For your safety, cleaning of
the main burner should be performed only
by qualified service personnel.
For cleaning, a vacuum cleaner can be
used on the burner.
!
Proper burner pattern.
Care and cleaning of the water heater.
Vacation and Extended Shut-Down
If the water heater is to remain idle for an
extended period of time, the power and
water to the appliance should be turned
off.
The water heater and piping should be
drained if they might be subjected to
freezing temperatures.
After a long shut-down period, the water
heater’s operation and controls should be
checked by qualified service personnel.
NOTICE: Refer to the Freeze
Protection Section on page 28.
Housekeeping continued
CLEANING THE AIR INTAKE FILTER:
●
Make sure the unit is OFF and the
electrical power supply has been
disconnected.
●
Unscrew the holding screw to the right
of the filter, and slide the filter down.
●
Using a vacuum cleaner, remove any
loose dust particles. DO NOT tap the
filter as it may deform and/or damage
the filter.
●
To remove severe dust, use a soft brush
and wash with running water.
●
Allow the filter to dry completely
before reinstalling the filter on the
water heater. Be sure to secure the filter
by lining the guide tab in the hole and
tightening the screw.
CLEANING THE WATER HEATER
AND REMOTE CONTROL(S):
●
Make sure the unit is OFF and the
electrical power supply has been
disconnected.
●
DO NOT
scrub the appliance with a
brush.
●
Use only mild soapy water, other
cleaners may damage the surface of the
water heater.
●
DO NOT
remove any label including
the rating plate while cleaning or
servicing.
●
DO NOT
splash water on the remote
controls when cleaning.
DANGER: DO NOT attempt
to operate the water heater
without the air intake filter. DO
NOT alter the proving switch to
force the unit to operate without
the air intake filter.
Notice:
The water heater may
not work if the air intake filter
is severely clogged.
!
Blue Flame
