72
PA-5400 SERIES NEXT-GEN FIREWALL HARDWARE REFERENCE | Service the PA-5400 Series Firewall
Hardware
©
2021 Palo Alto Networks, Inc.
Purpose
Command
To enable NCs after inserting them into the same slot numbers on
each firewall in an HA configuration, run the following command:
admin@PA-5450> request chassis power-on slot <slot-
number> target ha-pair
For example, to enable NCs installed in slot 2 of both firewalls, run the
following command:
admin@PA-5450> request chassis power-on slot 2
target ha-pair
You can use the
ha-pair
option in an HA configuration for many of
the slot control commands.
Replace a PA-5400 Series Data Processor Card (DPC)
Learn how to replace a DPC.
•
Replace a PA-5450 Data Processor Card (DPC)
Replace a PA-5450 Data Processor Card (DPC)
STEP 1 |
Put the provided ESD wrist strap on your wrist ensuring that the metal contact is touching your
skin. Then attach (snap) one end of the ground cable to the wrist strap and remove the alligator
clip from the banana clip on the other end of the ESD grounding cable. Plug the banana clip
end into one of the ESD ports located on the front of the appliance before handling ESD
sensitive hardware. For details on the ESD port location, see
.
STEP 2 |
Push the front tabs on the DPC towards the center, prompting a click. This will cause ejector
handles on the front of the card to rotate outward and unlock the card.
STEP 3 |
Grip the front ejector handles and gently pull the card out of its slot.
The below image shows a Management Processor Card (MPC); however, the procedure
to install the DPC is the same.