9
GETTING STARTED
SAFETY / SPECIFICATIONS
ASSEMBLY / INSTALLATION
OPERATION
TROUBLESHOOTING
MAINTENANCE / REPAIR
OPERATION - DRILL BIT SHARPENING
ACCESSORY
Before installing any accessories to the
machine, make sure the machine is turned
off and unplugged completely from its power source.
Installing the twist drill bit accessory into the tool
carrier head
There is no need to remove the Tool Carrier Head for single edge
burin bits. To sharpen a single edge bit, insert it into the collet and
tightening the collet with the Collet Crank Handle.
Likewise, you do not have to remove the Tool Carrier Head
to sharpen a twist drill bit. To sharpen a bit use the Drill Bit
Accessory and follow the steps below.
1. Remove the stop from the bushing on the Tool Carrier Head.
2. Insert the small shaft of the twist drill bit accessory into the
bushing hole. The larger shaft fits into the collet.
3. Insert and tighten the collet with the Collet Crank Handle
4. Insert the twist drill bit into the accessory holder and move
the ring up so the bit is close to the cup wheel
5. Make the final angle and distance adjustments using the
Grinder / Sharpener’s components.
Installing the end mill accessory onto the tool carrier
To use the mill end accessory, it is necessary to remove the tool
carrier head and replace it with the end mill accessory.
1. Release the Tool Carrier Head horizontal rotation axis
clamping lever.
2. Loosen the knurled screw on the right side of the of the Tool
Carrier Head. The head will slide off it the tool carrier. Make
certain to retain the wedge key.
5. Slide the end mill accessory onto the tool carrier. Make sure
the wedge key is in its proper position. Tighten the knurled
screw on the right side of the accessory.
6. Insert the end mill into the collet and tighten it.
7. Adjust the flute rotation control pointer to that the end mill can
rotate as it is being sharpened.
8. Make the final angle and distance adjustments using the
Grinder / Sharpener’s components.
Installing the lathe tool accessory onto the tool
carrier
To use the lathe cutter accessory, it is necessary to remove the
Tool Carrier Head and replace it with the lathe cutter accessory.
1. Release the Tool Carrier Head horizontal rotation axis
clamping lever.
2. Loosen the knurled screw on the right side of the of the tool
carrier head. The head will slide off it the tool carrier. Make
certain to retain the wedge key.
5. Slide the end mill accessory onto the tool carrier. Make sure
the wedge key is in its proper position. Tighten the knurled
screw on the right side of the accessory.
6. Insert the end mill into the collet and tighten it.
NOTES
