Palfinger PC 3800, Operating Manual

Page: 125 / 158

Chapter 11 Service
General
Note!
All service work must be carried out by PALFINGER service partners
in compliance with the PALFINGER training documents and service
records. Non-compliance results in loss of any warranty and liability.
Time left until next service - refer to Operating hours counter.
The operating company must arrange a service when the operating hour counter indicates it. For
further information, please refer to service manual (supplied with crane).
Keep all service records. Every service and repair must be recorded in the service manual and signed
or stamped by a PALFINGER service partner.
Preparing for service:
1. Clean the device (refer to 'Cleaning' in chapter 10).
2. Make a visual check (refer to 'Visual inspection' in chapter 10).
Check of threaded fasteners
Caution!
Loose, damaged or over-tightened threaded connections
can break under load. There is risk of fatal injury.
Note!
Tighten the screws only using the torque wrench and applying
the prescribed torque.
ISO bolt torques in Nm (ft.lbs): Tolerance range +/- 10%
Screws: DIN EN ISO 4762, 4014
Nuts: DIN EN ISO 4032
Washers: DIN EN ISO 7090
119