36
Palax D410 Pro+
Translation
1-2020
Lubricating the spool shifter
The spool shifter is equipped with a pin and a
ball joint that require regular maintenance
and lubrication.
Fig. 32.
1
Lift up the edge of the protective rubber
for the spool shifter.
2
Spray lubricant on both sides of the pin
and on the ball joint.
3
Also check that the protective rubber is
intact.
Figure 32
Structure of the detent end and the correct order of the parts
Keep the cover C of the detent end depressed while undoing the screws B, Fig. 33, as the stiff
springs can throw away the cover. Then also the springs and the balls of the detent part can be
thrown away.
When re-assembling the detent end, apply a small amount of Vaseline into the holes A in the
detent end. This ensures the small balls will stay properly in position during the assembly. Make
sure that the parts D and E come in the right position, as shown in the picture, and the drain
holes for condensed water always point downward.
8.8
Figure 33
Initial settings of the valve
The valve has been adjusted and test run at the factory.
The initial settings do not usually change so there is rarely any need for readjustment.
Changing the saw-chain
