25
Palax D410 Pro+
Translation
1-2020
Powered by tractor
The tractor's output must be at least 30 h.p.
Always hitch the machine to the three-point linkage of the tractor.
When transporting the machine, the weight of the tractor must be at least 2,800 kg.
A suitably sized PTO shaft is, for example, BONDIOLI 103 or WALTERSCHEID W 2200.
No safety clutch is required in the PTO shaft.
Only use a fault-free PTO shaft and always attach the shaft-guard chains to the machine.
Ensure sufficient space for unobstructed operation of the PTO shaft.
Hang the PTO shaft on the hook on the machine when disconnecting it from the tractor.
NOTE!
When starting the machine in frosty conditions, let it idle for 5-10 minutes to warm up
the oil. Max. rotational speed is 450 r.p.m.
Electrically powered machine
The output of the motor is 11 kW and its speed of rotation is about 1,450 r.p.m.
The machine is equipped with an automatic Y-D starter with emergency stop. Emergency stop,
Fig. 19 - 4.
All electric installation work has been completed.
Correct fuse size for the 380 V system is 25 A slow. The recommended fuse size is 32 A slow.
The required cross-section of the extension cord is 6 mm
2
.
Before starting up the machine, check that it rotates in the direction shown by the arrow at the
end of the motor.
Check the direction of rotation by allowing the motor to run for a short while and, after that,
stopping it immediately.
The direction of rotation can be reversed using the phase-switch in the appliance inlet. Fig. 19 -
5.
The machine may only be connected to a power supply with a fault current switch of 30 mA.
The machine requires a 5-pole extension cable (L1, L2, L3, N and PE) to operate.
NOTE!
Electric installation work may only be carried out by a professional.
