29
Palax C750
Translation
1-2018
particularly important if the machine is to be left standing for several months. If the
parts of the detent have become rusty, the machine will not operate flawlessly.
24
B
A
25
9.16
Detent end of the valve, Fig. 24 A
There is a small hole in the middle of the end plate of the detent end of the valve for
spraying lubricant onto the moving parts of the valve detent.
Only use oil that does not congeal in frost.
The easiest way is to use a spray bottle with a nozzle and pipe, Fig. 25.
1. Remove the cap screw on the end plate.
2. Insert the spray pipe in the hole and press 2-3 times for about 1 second at a time.
3. The oil spreads smoothly on the moving parts of the detent end.
9.17
Lubricating the spool shifter, Fig. 24 B
The spool shifter is equipped with a pin and a ball joint that require regular
maintenance and lubrication.
1. Lift up the edge of the protective rubber of the spool shifter.
2. Spray lubricant on both sides of the pin and on the ball joint.
3. At the same time, check that the rubber is intact.
9.18
Structure of the detent end and the correct order of the parts, Fig. 26
Keep cover C of the detent end depressed while opening screws C, as the stiff springs can
throw the cover off. This can also make the springs and balls of the detent fly off.
In connection with assembly of the detent end, apply a small amount of Vaseline to holes
A of the detent. This ensures the balls stay properly in position during assembly. Make
sure that parts D and E line up in the right way, as shown in the picture, and that the
condensed-water drain holes always point downward.
26
A
B
C
D
E
F
