1
CONTENTS OF THE PAINLESS KIT
Refer to the
Contents Figure
(below)
to take inventory. See that you have everything
you’re intended to have in this kit. If you find that anything is missing or damaged, please
contact the dealer where you obtained the kit or Painless Performance at (800) 423-9696.
The Painless Trail Rocker Kit should contain the following:
4, 6, or 8-Switch Customizable Trail Rocker Switch Panel.
Powder-coated Switch Panel Box
Roll Bar Straps: (2) 1
5
∕
8
” & (2) 1 ¾”
Parts Kits
Pre-Terminated Winch Wires.
o
4 & 6 Switch Kits ONLY: Additional switch wires
This manual: 90639
SMALL PARTS
Painless harnesses include parts kits that contain the terminals, fuses, screws, and nuts
necessary for a professional installation. Many of the terminals are non-insulated and will require
heat shrink to be applied after the terminal has been properly crimped. Waterproof heat shrink
has been supplied. These non-insulated terminals allow you to make clean, weatherproof
connections that look like a factory installed wiring system. When crimping these terminals, take
special notice of the split in each terminal. Make sure the smooth side of the jaw on the crimper
goes towards this split.
