Packard Bell ENTJ75, Service Manual

Page: 70 / 164

CHAPTER 3: Replacing notebook components
64
Replacing the LCD panel assembly
Tools you need to complete this task:
Screws removed during this task:
•
3 black M2.5×6 (keyboard cover)
•
2 black M2.5×6 (LCD panel hinges - bottom)
•
2 black M2.5×6+Nylok (LCD panel hinges - top)
To replace the LCD panel assembly:
1
Complete the steps in “Preparing the notebook” on page 47 .
2
If the notebook has a wireless card installed, complete the steps in
“Removing the bay cover” on page 49 , and then unplug the antenna cables.
If there’s no wireless card installed, proceed to step 5 .
3
Remove the keyboard by performing steps 2 – 4 of the “Replacing the
keyboard” procedure on page 62 .
4
Turn the notebook over so the base is facing up.
5
Remove the base screws that secure the LCD panel hinges.
Caution
The keyboard is connected to the notebook through a keyboard
cable. Disconnect this cable first before pulling the keyboard away
from the palm rest assembly.
Phillips #0 screwdriver
Flat screwdriver or Non-marring plastic scribe