Packard Bell EasyNote NM85, Service Manual

Page: 98 / 142

CHAPTER 3: Replacing notebook components
92
Replacing the LCD assembly lid
Tools you need to complete this task:
Screws removed during this task:
•
1 black M2×3 (hard drive)
•
1 black M2.5×6 (optical drive)
•
2 M2.5×6 black (palm rest - top side)
•
6 M2×3 black (palm rest - base side) - Indicated by A
in step 13 of the “Replacing the palm rest” procedure on page 49
•
9 black M2.5×6 (palm rest - base side) -
Indicated by B in step 13 of the “Replacing the palm rest” procedure on
page 49
•
2 black M2.5×4 (LCD front panel)
•
6 chrome M2.5×4 (LCD panel)
To replace the LCD assembly lid:
1
Complete the steps in “Preparing the notebook” on page 37 .
2
Remove the LCD panel assembly by performing steps 2 – 15 of the
“Replacing the LCD panel assembly” procedure on page 61 .
3
Remove the LCD front panel by performing steps 3 – 5 of the “Replacing the
LCD front panel” procedure on page 79 .
4
Remove the LCD panel by performing steps 4 – 6 of the “Replacing the LCD
panel” procedure on page 83 .
5
If you are going to use the same webcam, microphone and wireless
antennas, remove these items from the old LCD assembly lid and attach
them to the new one. Refer to the related replacement procedure on previous
pages for instructions.
6
Place the LCD panel with hinge brackets back on the LCD assembly lid.
7
Return the panel bracket screws to their places.
8
Reinstall the LCD front panel by performing steps 6 – 9 of the “Replacing the
LCD front panel” procedure on page 79 .
Make sure the webcam lens is aligned with camera peephole on the LCD
front panel before you secure the panel in place.
9
Reinstall the LCD panel assembly by following the steps 16 – 26 of the
“Replacing the LCD panel assembly” procedure on page 61 .
10
Reinstall the palm rest by performing steps 17 – 19 of the “Replacing the palm
rest” procedure on page 49 .
Phillips #0 screwdriver
Flat screwdriver or Non-marring plastic scribe