Packard Bell EasyNote NM85, Service Manual

Page: 109 / 142

www.packardbell.com
103
No-beep error messages
I/O device IRQ conflict
■
Run “Load Setup Defaults” using the BIOS Setup Utility, then reboot
the notebook.
■
Test or replace the CMOS battery, run the BIOS Setup Utility to
reconfigure system time, then reboot the system.
■
Test or replace the system board.
Operating system not found
■
Run the BIOS Setup Utility and see if fixed disk and drive A: are
properly identified.
■
Test or replace the diskette drive
■
Test or replace the hard disk drive
■
Test or replace the system board
No-beep Error Messages FRU/Action in Sequence
No beep, power-on indicator turns off and LCD
is blank.
■
Test the power source (battery pack and power adapter). See “Testing
the power system” on page 98.
■
Make sure that every connector is connected tightly and correctly.
■
Reconnect the SO-DIMM.
■
Test or replace the LED board.
■
Test or replace the system board.
No beep, power-on indicator turns on and LCD
is blank.
■
Test the power source (battery pack and power adapter). See “Testing
the power system” on page 98.
■
Reconnect the LCD connector
■
Check the hard disk drive.
■
Check the LCD inverter ID.
■
Check the LCD cable.
■
Test or replace the LCD inverter.
■
Test or replace the LCD.
■
Test or replace the system board.
No beep, power-on indicator turns on and LCD
is blank. But you can see POST on an external
CRT.
■
Reconnect the LCD connectors.
■
Check the LCD inverter ID.
■
Check the LCD cable.
■
Test or replace the LCD inverter.
■
Test or replace the LCD.
■
Test or replace the system board.
No beep, power-on indicator turns on and a
blinking cursor shown on LCD during POST.
■
Make sure that every connector is connected tightly and correctly.
■
Test or replace the system board.
No beep during POST but system runs correctly.
■
Test or replace the speaker.
■
Test or replace the system board.
Error Messages FRU/Action Sequence