Packard Bell DIGITAL TV 170 / 230 / 300 SW, Owner'S Manual

Page: 7 / 156

7
R
EMOTE CONTROL
All the functions can be controlled with the remote control. Some functions can also be adjusted
with the buttons on the front panel of the set.
Before you use the remote control, please install the batteries.
I
NSERTING BATTERIES
1. Remove the battery cover by pulling it upward in the direction shown by the arrow.
2. Insert the batteries with correct polarity ("+" to "+", and "-" to "-").
3. Replace the battery compartment cover.
• Install two high-quality 1.5V "AAA" alkaline batteries. Don't mix old batteries with new batteries.
• Remove batteries if the remote control will not be in use for a long time. Liquid leakage from
old batteries may cause operation failure.
Notes for using remote control :
• Make sure there are no objects between the remote control and its sensor.
• Do not place the remote control near a heater or in damp place. Strong impact to the remote
control may cause operation failure.
• The signal from the remote control can be disturbed by sun light or other bright light. If this
happens, darken the room or move the TV.
1. POWER
Turns the TV on or off standby mode.
2. MUTE
Turns the sound on and off.
3. NUMBER buttons
Selects programme numbers.
4. PSM (Picture Status Memory)
Recalls your preferred picture setting
5. SSM (Sound Status Memory)
Recalls your preferred sound setting
6. I/II
Selects the language during dual language broadcast.
Selects the sound output.
7. MENU
Displays a main menu.
8. TV/AV
Selects TV, SCART1, SCART2*, S-VIDEO and PC-
Analogue or PC-Digital* mode.
Clears the menu from the screen.