shoulder. Tilt the floor sander back so that the
sanding disc does not touch the floor or work
piece.
5.
Switch ON by pushing the ON/OFF switch to (I)
position and hold in place with your thumb. To
switch OFF (O), release the pressure on the
switch and it will automatically return to the OFF
position.
6.
Now lower the floor sander slowly forward so
that the abrasive disc comes into contact with the
floor or work piece. At the same time move the
machine in a sideways motion so when the
abrasive disc comes into contact with the work
surface it is moving to one side. This will ensure
that the sander does not dwell in one position
and damage the floor or work piece.
i.
Always ensure that the floor sander is
moving when in operation and the
sanding disc is in contact with the floor.
ii.
Never lift the back of the machine when
sanding.
iii.
Never apply pressure to try to increase the
rate of sanding. Damage to the floor or
work piece will occur.
iv.
Never bounce or drop the floor sander on
to the floor or work piece, always lower the
machine gently.
v.
Never dwell in one place, move steadily at
all times.
vi.
Never allow the power cable to come into
contact with the sanding disc.
7.
When the dust in the dust bag reaches the ‘MAX’
line stop sanding. Switch OFF (O) and
disconnect the power cable from the power
supply and remove the paper dust bag. Turn the
top of the paper dust bag over to stop the escape
of dust and dispose of into a suitable container.
Never reuse the paper dust bag or empty it.
Never dispose of it into a fire. If the cloth bag is
used empty into a suitable container being
careful to contain the dust. Do not dispose of the
contents into a fire.
CAUTION - the
is a powerful machine.
Always ensure you have a firm grip
before switching on.
CAUTION - to prevent damage to the
floor surface, work piece or machine
follow these rules.
Pacific Wolverine PF7
Edger Sander
3
8.
Fit a new paper dust bag, or refit the cloth bag.
Reconnect the floor sander to the power supply
and continue sanding.
9.
When taking a break from work switch OFF ‘O’
and disconnect the power cable from the supply,
remove and dispose of the paper dust bag, or
empty the cloth bag as detailed in 7. above.
Never leave the floor sander unattended with a
dust bag in place containing dust.
10. On completion disconnect the power cable from
the supply. Remove and dispose of the paper
dust bag, or empty the cloth bag as detailed in 7.
above. Replace the bag frame in its up position
and stow the power cable. Leave the old abrasive
disc inplace to protect the sanding disc. Carry out
maintenance as recommended in Maintenance
and Servicing.
DANGER - never leave the floor sander
unattended with dust in the dust bag.
Always remove the dust bag and dispose
of into a suitable container.
