9
OWNER’S
INFORMATION
Wall mounting
The Proflame remote control is supplied with an adapter for wall mounting.
Install the controller 1.5 m above floor level, well away from heat sources, kitchens, doors or
windows.
Metallic structures or radio interferences can reduce the operative distance of the device.
Make sure to attach the adapter in a level plane without any distortion. Proceed as follows:
• Detach the adapter from the body of the remote control; see Fig. A.
• Position the adapter on the wall, mark the points for the fixing holes and drill the wall.
• Fix the adapter on the wall using the mounting hardware supplied with the remote control.
• Insert the remote control onto the adapter as shown in Fig. B.
Figure A: Detach the adapter from the body
Figue B: Adapter and remote control
OPERATING PROCEDURE
Initializing the System for the first time
Power the receiver. Activate the procedure of the receiver
address programming, see the receiver instruction (*).
The Receiver will “beep” three (3) times to indicate that
it is ready to synchronize with a Transmitter. Install the
3 AAA type batteries in the Transmitter battery bay, located
on the base of the Transmitter. (Fig. 3) With the batteries
already installed in the Transmitter, push the On button.
The Receiver w
ill “beep” four times to indicate the
Transmitter’s command is accepted and sets to the particular
code of that Transmitter. The system is now initialized.
(*) The receiver may be independent or integrated to the IFC hearth
appliance control module. The receiver instruction may not be
independent when part of the IFC.
Figure 3
Summary of Contents for G963
Page 14: ...14 OWNER S INFORMATION DIMENSIONAL DRAWINGS Fig 19 PROFLAME Transmitter dimensional drawing ...
Page 16: ...16 OWNER S INFORMATION Lighting Instructions ...
Page 17: ...17 INSTALLER INFORMATION G963 Fireplace Dimensions Figure 20 Fireplace dimensions ...
