-42-
Throttle Operated Power Seat Instructions
CAUTION: Only drive the scooter when the power seat is in the lowest position to avoid tipping.
1.
Position the DRIVE/SEAT switch to SEAT. A green LED will light up (See FIGURE 16).
IMPORTANT: Do not change the drive/seat switch position during opera-
tion (Doing so will cause the scooter to come to an abrubt stop). After releasing the
throttle, wait two seconds for the controls to completely cycle off before changing the
Drive/Seat switch or turning the key off. If the Drive/Seat switch is changed to the
seat position while driving, the scooter will stop quickly. If the switch is changed to
the drive position while running the seat or the key is turned off (before the controls
have fi nished cycling) the scooter will move a few inches. Always wait the two sec-
onds between operations.
~ BE SURE those around you do not unexpectedly operate the switch. ~
2.
To raise the seat, depress the throttle bar in the FORWARD position.
Note 1:
The seat motor will react just like the cart motor. The more pressure
you put on the throttle bar the faster you go up.
Note 2:
The speed adjustment knob position effects the speed of the seat motor.
The fastest speed setting is 10.
3.
To lower the seat depress the throttle bar to the REVERSE position.
Notes 1 & 2 apply.
1.
Your scooter is equipped with a safety sensor that will prevent you from driving
if the power seat is raised more than 1” or it is swiveled sideways. If either of these two
conditions occur, the seat motor LED on the throttle will be lit even if the selector on the
throttle is set to “Drive”. The light will go off once you lower the seat and/or rotate it for-
ward and wait 2 seconds after releasing the throttle.
2.
Make sure the seat is within an inch
of its lowest position.
3.
Make sure the swivel seat is facing
forward and is locked into place by the
handle on the side of the seat.
CAUTION:
Failure to have the seat facing forward
while driving could cause the safety sensor
discussed above to become activated
bringing the scooter to an abrupt stop.
4.
After the seat has been lowered and
locked facing forward, wait two seconds, position the DRIVE/SEAT switch on the throttle
to DRIVE and proceed with normal operation.
RAISING AND LOWERING THE SEAT
RESUMING TO DRIVE MODE
FIGURE 16. (RIGHT HAND THROTTLE)
LOW
FULL
10
5
1
Seat
Drive
Seat Motor
Indicator LED
Speed
Control
Knob
