-22-
Disassembly and Assembly of the PaceSaver Scooter
The
PaceSaver’s
patented separation makes it easy to disassemble and assemble.
Complete disassembly can be accomplished in seconds WITHOUT tools.
1. Remove the key from the switch. (It should already be in the OFF position since
it was placed there when you last got off the scooter).
2. Remove the armrests from the seat assembly if you fi nd this more convenient.
3. Unlock the seat lock, lift the seat assembly upward and set it aside. Lift off the rear
cover on units with one piece battery covers (Epsree, Eclipse, etc.).
4. Disconnect each battery. Depress the tab on the side of the three pin connector and pull
the two connectors apart.
5. Unfasten the velco backed battery hold down straps and remove both batteries.
6a. Disconnect the smaller 2-pin brake cable connector (for the 500 lb Atlas Model only,
see Figure 6).
6b. Disconnect the motor cable.
(Depress the tab on the side
of the single 4-pin connector
and pull the two cable ends apart.)
7. Disconnect the motor cable.
Depress the tab on the side of
the single four pin connector and
pull the two connectors apart.
8. Pull up on the L-handle pull pin located
just behind the chrome seat post.
9. Slide the front section away from the rear sec-
tion. Use caution since the sections will rock to
the ground once they become separated.
10. Push the tiller release lever to allow the tiller
to pivot backwards toward the fl oor pan
(See FIGURE 7).
Tiller
Release
Lever
FIGURE 6
Battery Cables
Brake Cable
Motor Cable
FIGURE 7
