-23-
The following is the procedure for assembling the PaceSaver Scooter.
With practice this will become easier and easier.
1. Align the silver tongue of the rear
section with the square tube on the front
section. Check that there are no cables
caught between the two sections.
Both sections should be resting on the
ground at this point (See FIGURE 8).
2. Begin to insert the tongue into the
square tube by pushing down on the
rear of the rear section while lifting
up on the chrome seat post of the
front section.
3. The two (2) sections will rock up
and partially slide together. Once the
sections cannot be lifted any higher, slide them together completely.
4. Insert the L-shaped pull pin into the hole just behind the seat post. Be certain pull pin
is inserted completely to its stop ring. It may be necessary to line up the holes in the tube
and the tongue before the pin can be inserted.
5. Push the tiller release and raise the tiller.
6a. Connect the large motor plug cable to the rear section. Push the plug straight in.
6b. Connect the two-pin brake plug cable for. (500 lb. Atlas Model only. see FIGURE 4 pg 21)
7. Put the batteries in place and securely fasten them down with the hold down straps.
8. Connect the battery cables. Align the receptacle and the plug. Push the plug straight in.
9. Place the seat assembly into the chrome seat post. Make sure the seat lock lever is in the unlock
position to avoid damage. Rotate the seat assembly to insure it is
lowered completely.
10. Get on the scooter, adjust the tiller, lock the seat lock, and go for a ride. Be sure to follow
the warnings and instructions written in this manual for operating the scooter.
FIGURE 8
