-29-
Offboard Battery Charger Instructions
The switch-mode battery charger provided is specially designed for use with your Pac-
eSaver wheelchair. In the unlikely event of failure we recommend replacement only with
a PaceSaver brand charger. The charger is intended for use with AGM or gelcell sealed
lead-acid deep cycle discharge type batteries only. This is a 24 volt DC charger for use
only with batteries connected for 24 volt DC service. Do Not use the charger with a car
starter battery.
The PaceSaver brand battery charger includes
• Microprocessor control allows switch-mode operation for faster charging.
• Light weight and compact size offers space advantages.
• All units feature Auto Voltage Select (AVS): One unit operates for 100 VAC, 120 VAC or 230 VAC.
• Power limited battery charging (using algorithm) depending on battery state of charge.
• Automatic shutoff and restart to compensate for battery self discharge.
• Reliable charging achieved through a multi-stage, multi-mode charging algorithm.
• Thermal protection prevents damage from over temperature conditions.
• Input & output protected by automotive electronic sensor.
• Output current limit so as not to exceed the maximum power and/or thermal capacity.
• Output short circuit and reverse polarity protection.
• LEDs indicate AC Power ON, Charging Status and Fault Conditions.
Refer to the instructions provided with the battery charger for detailed specifi cations and operation
information.
1. Connect the plug from the charger to
the cart battery charger outlet located in
the tiller (See FIGURE 2. page 15). Align
the white mark on the connector and push
fi rmly in until the plug is properly seated
(See FIGURE 9). This assures proper con-
nection to the batteries.
PLEASE NOTE
:
For your safety the scooter is equipped with
a charger safety lockout that will not allow
the scooter to operate while the charger plug
is plugged in.
2. Insert the charger AC power plug into a
properly wired household outlet.
3. Leave the charger on until the batteries are fully charged. This will be indicated by the
chargers L.E.D. When this point is reached, the charger will go into monitoring mode. This
mode can be left on indefi nitely without any harm to the battery.
4. Before driving the scooter disconnect the charger AC Power plug from the household outlet.
FIGURE 9
