Testing Your PaceMaster Silver XT
Your PaceMaster has been adjusted and tested at the factory. However, due to changes that can occur during shipment, it should be
tested prior to use. Once you have assembled your elliptical and it is located where it will be used, proceed as follows. (Do not make any
adjustments unless necessary.)
Follow the steps below to confirm proper operation of your elliptical after assembly.
Step One: Plug your PaceMaster Elliptical Cross Trainer into a power outlet. “PaceMaster” should appear in the Message Center.
Step Two: Pedal the elliptical; you should feel a smooth motion.
Step Three: Press the resistance (lower right window)
buttons to increase the resistance to 20 and then back to 1. You
should feel the different in effort required to pedal the elliptical as the resistance level raises.
Step Four: Check if your strides per minute (lower left window) increase when you pedal faster and decrease as you pedal slower.
If all steps have not passed please refer to Troubleshooting for assistance.
17