9
Testing Your Treadmill
Your PaceMaster has been adjusted and tested at the factory. However, due to changes that can occur during shipment, it should be
tested prior to use. Once you have assembled your treadmill and it is located where it will be used, proceed as follows. (Do not make any
adjustments unless necessary.)
For the purpose of this test, DO NOT stand on the tread belt. Once tested, always start and finish
on the tread belt
.
Follow the steps below to confirm proper operation of your treadmill after assembly.
Step One:
After your treadmill is in place and plugged in to the wall outlet, insert the magnetic safety key into the recess on the control panel.
Step Two:
Press the Incline
buttons to set your weight and the Speed
buttons to set your age, then press the
(ENTER)
button.
Step Three:
Set the workout speed by pressing the SPEED
button until the SPEED display shows 2.5 mph.
Step Four:
Press the START
(QUICK)
button. Within a few seconds, the tread belt will begin to move. The speed display will flash until the tread belt
has reached the set speed.
Step Five
:
After the treadmill has reached 2.5 mph, observe the tread belt to make sure it is reasonably centered. If the tread belt is not reasonably
centered, press the STOP
(RESET)
button and refer to “Centering the Tread Belt” in the Care and Maintenance section of this manual.
Once the tread belt is reasonably centered, run the treadmill at 2.5 mph for 2 minutes to be sure it remains centered.
Step Six
:
To test the elevation, the tread belt must be moving. Press the incline up
button to raise the elevation to 5% incline. The elevation
will be displayed in the INCLINE display window. Once it reaches 5%, press the incline down
button to reduce the incline to -3%,
then return the incline to 0%. If the treadmill does not elevate, or displays “Err” in the incline display consult the troubleshooting section of
this manual.
Step Seven
:
Press STOP
(RESET)
you are now ready to use your treadmill.
