6
A
A
B
B
HANDLEBAR
SIDE RAIL
SIDE RAIL
ADAPTOR
HANDLE BAR
SUPPORT TUBE
H
I
G
J
SIDE RAIL
ASSEMBLY INSTRUCTIONS
Assembly
Step One:
(see figure 1)
Carefully lower the handlebar on to its mounting brackets as
shown in figure 1. The mounting brackets must slide inside the
handle bar. With the handle bar in place install 2 screws (A) with
washers into both handlebar uprights as shown, do not tighten
these screws yet. Install 2 screws (B) with washers into both
handlebar uprights as shown; The following
MUST
be done in the
Order it is written.
Tighten the 4 screws (A) as shown in figure 1.
Tighten the 4 screws (B) as shown in figure 1.
Step Two:
(see figure 2)
Slide the side rail adaptors all the way onto the square handle
bar support tube. The side rails are labled left and right, slide
the side rails over the side rail adaptors on their respective
sides. The grip on the side rail must slide inside the control
panel till it can go no more.
Step Three:
(see figure 3)
Insert carriage bolt (G) through the hole in the bottom of the
side rail. Slide the side rail mounting bracket (H) on to the
bolt as shown. Push the carriage bolt through the frame rail
until it is protruding through the other side. Install the fender
washer (I) and the kep nut (J) on the threaded end of the
bolt. Tighten the 2 nuts (J) as shown in figure 3.
Figure 1
Figure 2
Figure 3
