-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
▲
I
NSTRUCTION
M
ANUAL
TERAPRESS TP
-
7100S
Mounting Press
Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1
-
520
-
882
-
6598 Fax +1
-
520
-
882
-
6599 email: [email protected] Web: https://www.metallographic.com
The
TERAPRESS TP 7100S
mounting press has been designed for mounting non
-
flammable
metallographic specimens up to 2
-
inch diameter. Always follow proper operational guidelines
and avoid contact with moving parts and hot assemblies. Seek appropriate medical care for
injuries.
1.3 Emergency Statement
2
!
Caution:
DO NOT POSITION HEAD OR OTHER BODY PARTS OVER THE
MOLD WHEN RAISING THE RAM TO REMOVE THE SPECIMEN MOUNT
!
During operation, the closure and upper parts of the heating and cooling block
can get very hot. For safety, do not touch the closure unit. Use protective
gloves if required.
!
Always completely screw tighten the bayonet cover and back off a fraction so it
is not too tight. Improper installation can result in hot molten mounting material
leaking (
danger of burning).
!
Initial cooling water coming into contact with mold will produce an initial burst
of steam. To avoid
danger of burning
, secure the drain line and use caution
when the
TERAPRESS TP 7100S
compression mounting press is in use.
!
Mold cylinder and ram get very hot during the mounting process. Take care
before changing (
danger of burning).
!
Mounting samples must be chemically compatible with the mounting material.
Do not mount flammable samples.
!
Before opening the unit, disconnect main power plug. Replacement parts
should be installed only by qualified personnel.
!
Follow proper operating instructions (Section 4.0) and obtain proper training
before operation.
!
Do not leave press unattended during operation.
!
Turn off external water supply when press is not in operation.
1.2 Safety Precautions (continued)
