-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
▲
I
NSTRUCTION
M
ANUAL
TERAPRESS TP
-
7100S
Mounting Press
Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1
-
520
-
882
-
6598 Fax +1
-
520
-
882
-
6599 email: [email protected] Web: https://www.metallographic.com
Backside connections
Electrical connection:
Verify the operating voltage which is printed on the name plate. The
standard voltage is 110V; however, the system is also available in
220V.
Coolant drain:
The coolant drain line requires a 1/4
-
inch hose.
CAUTION:
The mold
temperature is very hot and the initial contact of the cooling water
turns to steam, which exits the drain hose at a very high temperature.
Coolant supply:
The coolant supply line requires an 8 mm hose. It is recommended
that the water supply be turned off when the unit is not in use. Inlet
water should be clean and contamination
-
free to extend the life and
cooling performance of the system.
Air supply:
Air supply line requires a 6 mm pressure hose. Clean dry air is
recommended (a filter lubricator is recommended)
Solenoid regulator:
To adjust cooling times, adjust this regulator to open the auxiliary
solenoid.
8
Air supply
Serial name
plate
Main power switch
Electrical connection
Drain
Water supply
Solenoid regulator
