PEC017
5/3/2018
Page
47
of
105
Remote PTO Governor Preprogrammed
Speed Control Switch #1
979
42
2
Switch signal which indicates that the
remote PTO governor toggle switch #1 is
in the enabled (ON) position. If the
toggle switch is enabled and other
conditions are satisfied then the remote
PTO governor feature is activated and
the PTO governor will control at the
preprogrammed speed #1.
0 = Off
1 = On
2 = Error
3 = Not available
Remote PTO Governor Preprogrammed
Speed Control Switch #2
3447
58
2
Switch signal which indicates that the
remote PTO governor toggle switch #2 is
in the enabled (ON) position. If the
toggle switch is enabled and other
conditions are satisfied then the remote
PTO governor control feature is
activated and the PTO governor will
control at the preprogrammed speed
#2.
0 = Off
1 = On
2 = Error
3 = Not available
EEC2 (PGN 61443) – PTO Mode Remote Throttle
Name
SPN
SB
L
Description
Remote Accelerator Pedal Position
974
24
8
The ratio of actual position of the
remote analog engine speed/torque
request input device (such as an
accelerator pedal or throttle lever) to
the maximum position of the input
device. (0% to 100%)
TSC1 (PGN 0) – Torque/Speed Control
Name
SPN
SB
L
Description
Engine Override Control Mode
695
0
2
0 = Override disabled - Disable any
existing control commanded by the
source of this command. Required
before stopping transmission of TSC1
message to avoid TSC1 low rate faults.
1 = Speed control - Govern speed to the
included “desired speed” value (SPN
898). In this mode, engine speed will be
limited to Maximum Engine Speed using
Switch Inputs (N086).
2 = Torque control - Control torque to
the included “desired torque” value (SPN
518). In this mode, engine speed will be
limited to Maximum Engine Speed using
Pedal Input (N076).
3 = Speed/torque limit control - Limit
speed and/or torque based on the
included limit values. In this mode,
engine speed will be limited to
Maximum Engine Speed using Switch
Inputs (N086).
