Pacbrake is a registered trademark of Pacbrake Co.
4
HP10216 AMP AIR SUSPENSION KIT
L6360
ECN 1-1789
L6360_Rev4_17.07.2018
2A
2B
2C
2D
2
REMOVE THE LINE HOLDER
• Remove and discard the ABS line holder located on the left side
(driver's side) of the frame rail, on the inside of the frame, just
forward of the axle
• Pull the ABS line holders out from the frame and remove from the
ABS line. They are attached to the bottom of the frame, behind the
axle, on the left (driver's) and right (passenger's) hand side.
(See picture 2C)
• Use a small screw driver to unhook the clamp from the line and
remove it. Discard the clamp since it will no longer be used.
• Install the small cable clamps facing up, onto the ABS line where
the stock line holders were attached with the hole facing forward on
the line. Do this on both sides. (see picture 2D)
• Leave the ABS line hanging loose for later installation.
CAUTION:
BECAUSE THE EMERGENCY BRAKE CABLE IS IN A
LOCATION THAT MAKES IT POSSIBLE TO RUB A HOLE IN
THE SIDE OF THE AIR SPRING, IT WILL BE NECESSARY TO
RELOCATE IT AWAY FROM THE AREA WHERE THE AIR SPRING
IS INSTALLED.
