![background image](http://html.mh-extra.com/html/ozito/mps-700/mps-700_instruction-manual_1666503011.webp)
10. Remove the spray gun from the mobile base spray gun holder and point at a piece
of cardboard or newspaper. Turn on using On/Off switch (4) on the mobile base.
Note:
When the mobile base is switched on the air will flow continually from the air
cap (1).
11.
Adjusting the Spray Gun
10.
Squeeze the trigger (12) while aiming the gun at a
piece of cardboard or scrap material and wait the
the spray to come out. Turn the spray regulator dial
(13) to required position for optimum results (Fig. 6).
Note:
The spray regulator dial (13) is a stop that limits
distance the trigger can be pressed.
Choice of spraying pattern (Fig. 7)
A = vertical fan
- for horizontal surfaces
B = horizontal fan
- for vertical surfaces
C = round fan
- for corners, edges and other hard to
access places.
Adjusting the required spray pattern (Fig. 8): With the air
cap nut loosened, turn air cap (1) to the required spray
pattern.
Caution:
Never open trigger (12) when making adjustments on the air cap.
Spraying Technique
The spraying result depends considerably on now smooth and clean the surface is
before spraying is begun. For this reason the surface should be carefully prepared and
kept free of dust. Surfaces and parts not to be sprayed should be masked by covering
with sticky tape and newspaper. It is advisable to carry out a trial spraying onto
cardboard or a similar surface to find the most suitable spray gun adjustments.
Note:
Start spraying outside the surface to be sprayed and avoid stopping in the
middle of the surface being sprayed.
OPERATION (cont.)
10
1
2
Fig. 8
Fig. 6
A
B
C
Fig. 7
Air cap nut
Summary of Contents for MPS-700
Page 1: ......