CLEANING
Clean After Every Use
After every use it is essential that you clean the gun thoroughly. This will prevent any
blockages occurring and provide reliable performance when you next come to use it.
1. Turn off device. Open trigger so that the coating material in spray gun runs back
into the container.
2. Unscrew the container. Return remaining material into the material can.
3. Clean the container. Remove the suction tube by
turning counter-clockwise and pull gently to
disassemble from the paint head. Disassemble the
suction tube (Fig.13) for further cleaning by turning
clockwise then pull to disassemble.
Note:
Only use solvent with a flash point of over 21°C
4. Take note of the 3 holes on the suction tube, if
blocked clean using the provided cleaning needle
(Fig. 14). The 3 holes are used to pressurize the paint
pot (11) for the paint pickup. If these holes are
partially blocked it will result in uneven and
inconsistent spraying.
5. Thoroughly clean the suction tube using clear solvent
or water before reassembling.
6. Re-fit suction tube and fill container with solvent or water.
7. Screw container back in place. Turn on device and spray the solvent or water into
a container.
8. Repeat the above procedure until clear solvent or water comes out of the nozzle.
9. Turn off device.
10. Then completely empty the container. Always keep the container seal free of
coating material and check for damage.
11. If the housing of the gun requires cleaning dip a cloth in the solvent or water,
ensuring the cloth is not dripping, wipe the exterior of the spray gun.
12. Unscrew the air cap nut. Remove air cap. Clean the air cap and nozzle with brush
and solvent or water.
13. Prior to storing the mobile paint station, ensure it is completely dry. This will
minimise residue build-up for the next use.
Note:
Ozito Industries will not be responsible for any damage or injuries caused by the
repair of the tool by an unauthorised person or by mishandling of the tool.
12
Fig. 13
Fig. 14
Summary of Contents for MPS-700
Page 1: ......
