MAINTENANCE
13
If required the spray gun plunger can be removed and cleaned. This is a
maintenance task and should not be required on a frequent basis. If the paint has
been allowed to dry in the paint head or the spray gun has had a lot of use then
removing and cleaning or replacing the plunger may restore the original spray gun
performance.
1. If attached remove the air hose (10) from the
spray gun. Using a 8mm socket (not provided)
carefully unscrew and remove the spray gun
plunger assemble from the rear of the spray
gun (Fig. 15).
2. Clean the spray gun plunger assembly and spray gun, remove any paint using
clear solvent or water.
3. After cleaning reassemble the plunger assembly
in the correct order (Fig. 16) and refit to the rear
of the spray gun.
Note:
Do not use abrasive material to clean the plunger as this may affect the
performance of the spray gun.
Fig. 15
Fig. 16
Summary of Contents for MPS-700
Page 1: ......
