![background image](http://html1.mh-extra.com/html/ozito/hpw-1885k/hpw-1885k_instruction-manual_1666641006.webp)
5. TROUBLESHOOTING
WARNING!
ALWAYS TEST THE SPRAY JET ON A
SMALL INCONSPICUOUS AREA TO ENSURE THE
SETTINGS WON’T CAUSE ANY DAMAGE TO THE
SPRAYED SURFACE.
WARNING!
DO NOT USE PRESSURE WASHERS
WHILE WORKING ON LADDERS. THE RECOIL FROM
OPERATING THE SPRAY GUN COULD UNBALANCE YOU
AND THROW YOU OFF THE LADDER.
Usage Tips
Pressure washers are designed to remove dirt and grime. They are
not designed to strip paint or kill mildew from surfaces.
1. Lay tarps around the house perimeter to protect plants from
debris and accidental spray.
2. Hold the spray jet at a 45°
angle and at a suitable
distance to the surface being
washed to prevent gouging
the surface. Do not hold the
spray jet straight on to the
surface as this drives dirt in
rather than washing it off.
3. Work small areas at a time
and use overlapping strokes
to prevent streaks.
WARNING!
WHEN CLEANING WALLS, DO NOT SPRAY
WINDOWS AS THE HIGH PRESSURE CAN CRACK THEM.
Washing Your Car
1. With the adjustable spray nozzle attached and on a medium to
wide spray setting, loosen and rinse off any dirt.
2. Change to the foam dispenser nozzle and coat your car in a
layer of foam. Allow the soap to sit for a few minutes (or as
directed by the manufacturer) for it to penetrate any dirt or
grime.
Note:
Keep the car surface wet to prevent any discolouration or
damage from the detergent.
3. Swap back to the adjustable spray nozzle and rinse down your
car on the wide spray setting.
RELEASE
WARNING!
DURING USE OF HIGH PRESSURE
CLEANERS, AEROSOLS MAY BE FORMED. INHALATION
OF AEROSOLS CAN BE HAZARDOUS TO HEALTH.
Symptom
Possible Cause
Suggested Solution
Fluctuating
pressure
The pump is drawing
in air
Check that the
connections are
securely installed.
Check the hoses for
kinks and punctures
Insufficient water
supply
Increase the water
supply at the tap,
check for blockages or
kinks in the hose and/
or swap to a larger
diameter hose
The machine
stops mid-use
Incorrect mains voltage
Unplug other
appliances.
Check that the power
supply corresponds to
the specifications on
the datalabel
Overload protection
activated
Allow the machine to
cool for 5 minutes.
Refer to the
Overload
Protection
section
Partially blocked water
jet
Clean the nozzle with
the supplied cleaning
needle
Pulsing/
inconsistent
spray
Air in the inlet hose/
pump
Pull and hold the spray
gun trigger and allow
the machine to run
until working pressure
resumes
Inadequate water
supply
Increase the water
supply at the tap,
check for blockages or
kinks in the hose and/
or swap to a larger
diameter hose
Partially blocked water
jet
Clean the nozzle with
the supplied cleaning
needle
Kinked water hose
Unwind the water hose
fully
No water
emitted
Water filter blocked
Clean the inlet filter
Blocked nozzle
Clean the nozzle with
the supplied cleaning
needle
Insufficient water
supply
Increase the water
supply at the tap,
check for blockages or
kinks in the hose and/
or swap to a larger
diameter hose