![background image](http://html1.mh-extra.com/html/ozito/hpw-1885k/hpw-1885k_instruction-manual_1666641003.webp)
Attaching The Spray Gun & Accessories
1. Push the desired accessory
into the spray gun lance and
twist clockwise to lock it into
place.
Note:
If a longer reach is required, connect the extension lance to
the spray gun lance, and attach the desired accessory to the free
end of the extension lance.
Note:
There is a locking sleeve
on the patio cleaner and spray
gun to prevent the accessory
from coming loose during use.
Rotate the sleeve counter
clockwise until it tightens
up against the accessory it’s
connected to.
2. To disconnect the accessory, push the accessory towards the
spray gun, twist the accessory counter clockwise and pull it.
3. Push the end of the pressure
hose into the inlet port on the
spray gun until it clicks into
place.
4. Tug gently on the pressure hose to check that it is inserted
correctly.
WARNING!
PRESSURISED WATER. SHUT OFF WATER
SUPPLY, TURN OFF UNIT AND SQUEEZE THE SPRAY
GUN TRIGGER TO RELIEVE THE PRESSURE BEFORE
DISCONNECTING THE HIGH PRESSURE HOSE.
5. To disconnect the spray gun,
press and hold down the
quick release tab and pull
out the pressure hose.
2. ACCESSORIES
a.
b.
RELEASE
WARNING!
ENSURE THE TOOL IS TURNED OFF AND
DISCONNECTED FROM THE POWER SUPPLY BEFORE
PERFORMING ANY OF THE FOLLOWING OPERATIONS.
WARNING!
THIS PRODUCT MUST NOT BE CONNECTED
TO THE POTABLE WATER MAINS WITHOUT BACKFLOW
PREVENTION. CHECK LOCAL AND NATIONAL
PLUMBING REGULATIONS BEFORE CONNECTING THE
MACHINE TO THE POTABLE WATER MAINS.
a.
b.
RELEASE
a.
b.
RELEASE
RELEASE
a.
b.
RELEASE
Connecting The Water Supply
This pressure washer requires a pressurised water source with
a maximum pressure of 1MPa (145psi). It is recommended that
a reinforced garden hose (with minimum diameter of 12mm) is
used for the inlet connection. It cannot be used with a bucket and
siphon.
WARNING!
RUN WATER THROUGH THE GARDEN HOSE
BEFORE ATTACHING IT TO THE PRESSURE WASHER TO
PREVENT ANY SAND OR DIRT FROM ENTERING THE
UNIT.
1. Place the mesh inlet filter
into the hose adaptor, and
then screw this onto the
water inlet port.
Note:
The mesh inlet filter must
be in place to prevent impurities in the water source from entering
the unit and damaging the pump.
WARNING!
ENSURE THE GARDEN HOSE IS
ADEQUATELY RATED AND SUFFICIENTLY LONG FOR
THE INTENDED APPLICATION.
2. Push the standard quick
coupling adaptor on the end
of the garden hose onto the
hose adaptor on the pressure
washer until it clicks into
place.
Note:
The standard 12mm quick coupling adaptor should be used.
3. Pull gently on the hose to ensure the connection is secure.
Connecting The Pressure Hose
1. Push the flat end of the high
pressure hose into the water
outlet port and screw it
clockwise into place.