MAINTENANCE
DESCRIPTION OF SYMBOLS
WARNING!
BEFORE CLEANING THE APPLIANCE OR
CARRYING OUT ANY MAINTENANCE PROCEDURE,
MAKE SURE THAT IT IS DISCONNECTED FROM THE
POWER SUPPLY TO PREVENT ACCIDENTAL STARTING.
Machine not suitable for
connection to the potable water
mains
Ingress protection from water
Sound power level
Degrees Celsius
Wear gloves
Wear closed-toe shoes
Wear face protection
Wear hearing protection
Warning
Regulatory Compliance Mark
(RCM)
Warning! High pressure
jets can be dangerous if
not used properly. Do not
direct the jet at persons,
animals, live electrical
equipment or the
pressure washer itself.
Double insulated
V
Volts
Hz
W
Hertz
~
MPa
IPX5
L/min
psi
°C
Alternating Current
Watts
Megapascals
Revolutions or reciprocations
per minute
Pounds per square inch
mm
Millimetres
Read Instruction Manual
Power tools that are no longer usable should not
be disposed of with household waste but in an
environmentally friendly way. Please recycle where
facilities exist. Check with your local council authority for
recycling advice.
Recycling packaging reduces the need for landfill and raw
materials. Reuse of recycled material decreases pollution
in the environment. Please recycle packaging where
facilities exist. Check with your local council authority for
recycling advice.
CARING FOR THE ENVIRONMENT
SPARE PARTS
Spare parts can be ordered from the Special Orders Desk at your
local Bunnings Warehouse.
For further information, or any parts not listed here, visit
www.ozito.com.au or contact Ozito Customer Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: [email protected]
Cleaning
1. We recommend that you clean the tool immediately after you
use it.
2. Keep the tool free of dirt and dust as much as possible. Wipe the
equipment with a clean cloth.
3. Do not use cleaning agents or solvents; these may be
aggressive to the plastic parts in the appliance.
4. You must disconnect the hose and spraying tools from the
pressure washer before cleaning. Do not clean the pressure
washer with water.
5. The hose adaptor and mesh inlet filter must be inspected
regularly to avoid blockages and restriction in the water supply
to the unit.
Insert the cleaning needle
(supplied) into the adjustable
turbo lance outlet and move
it back and forth until any
debris is dislodged.
Storage
Pull the mains plug out of the socket, switch off the tool and make
sure that it is secured in such a way that it cannot be started up
again by any unauthorised person.
The nozzle can be stored on the accessory slots on the back of the
unit when not in use. Wind the water hose around the handle hook
and the power cord around the cord hook to keep them tidy and
out of the way. Empty the detergent bottle before storing the tool in
a dry location which is not accessible to unauthorised persons.
Supply Cords
If replacement of the supply cord is necessary, this has to be done
by a certified electrician in order to avoid a safety hazard.
Note:
Ozito Industries will not be responsible for any damage or
injuries caused by the repair of the tool by an unauthorised person
or by mishandling of the tool.
