![background image](http://html1.mh-extra.com/html/ozito/dtp-065/dtp-065_instruction-manual_1666898002.webp)
1
ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
11 Decompression Lever
12 Exhaust
13 Air Filter
14 Motor Housing
1. CONNECTING THE INLET
WARNING!
ENSURE THE ENGINE IS SHUT OFF AND
THE ON/OFF SWITCH IS IN THE OFF POSITION BEFORE
PERFORMING ANY OF THE FOLLOWING ASSEMBLY.
Connecting the Suction Inlet
Removing the Protection Covers
1 Place the filter
assembly into the
intake end of a
suction hose and
secure with a hose
clamp tightly.
2 Insert a hose
adaptor and an
o-ring into one of the
collars and fasten to
the outlet side of the
suction hose using a
hose clamp.
3 Screw the hose adaptor and
collar tightly onto the pumps
inlet in a clockwise direction to
secure in place.
Note:
Teflon tape (not supplied) is
recommended on threads
to ensure a water tight seal
and prevent any leakage.
The inlet allows for a 40mm (1
1/2
”) supply line to be connected and is
capable of a maximum suction height of 6m.
The pump inlet and outlet has been fitted with a protection cover for
transportation. These will need to be removed before connecting any
pipes.
CAUTION:
AVOID POSITIONING THE INLET PIPE HIGHER
THAN THE PUMP, AS THIS WOULD DELAY THE ESCAPE
OF AIR BUBBLES FROM THE INLET PIPE.
CAUTION:
THE INPUT HOSE OR PIPE SHOULD BE LOW
ENOUGH IN THE WATER TO ENSURE THAT IF THE
WATER LEVEL FALLS, THE PUMP WILL NOT RUN DRY.
ENSURE THAT THIS IS CHECKED WHEN IN OPERATION.
15 Filter
16 5m Suction Hose
17 Collars
18 O-rings
19 Outlet Caps
20 Hose Adaptors
21 Hose Clamps
22 Open Ended Spanners
(10mm, 12mm, 14mm, 17mm)
23 Screwdriver
KNOW YOUR PRODUCT
SETUP & PREPARATION
DIESEL PRESSURE WATER PUMP
ACCESSORIES
1
11
6
5
2
12
7
3
13
8
4
14
15 16
17 18 19 20 21 22 23
9
10
1 Priming Cap
2 Discharge Outlet
3 Suction Inlet
4 Pump Housing
5 Fuel Cap
6 Fuel Tank
7 Fuel Tap
8 Recoil Starter
9 Lockable Throttle
Knob
10 Oil Fill Plug