1
3. INSTALLATION
Connecting the Discharge Outlet
1 Insert a hose
adaptor and an
o-ring into one of the
collars.
2 Screw the hose adaptor and
collar tightly onto one of the
pump outlets in a clockwise
direction to secure in place.
Note:
Teflon tape (not supplied) is
recommended on threads
to ensure a water tight seal
and prevent any leakage.
3 Repeat this process to fit multiple outlets.
Ensure unused outlets are fitted with the supplied outlet caps to stop
water from expelling out of the discharge outlets.
The outlet allows for a 25.4mm (1”) and 40mm (1
1/2
”) pipe to be
connected and is capable of a maximum head of 55m.
The pump has 3 outlets (2x 25.4mm and 1x 40mm), which allows for
multiple outlets to be used to pump water simultaneously, however this
will result in lower pressure and flow rate.
2. CONNECTING THE OUTLET
NOTE:
TO USE THE PUMP IN PERMANENT INSTALLATIONS
WITH RIGID PIPES, INSTALL A NON-RETURN VALVE TO AVOID
THE FLUID BEING RE-CIRCULATED ONCE THE PUMP HAS
STOPPED.
CAUTION:
ALL CONNECTIONS MUST BE AIR TIGHT,
FAILURE TO DO SO MAY RESULT IN AN AIR LEAK
WHICH CAN PREVENT THE PUMP FROM PRIMING.
1 Ensure the pump is mounted to a rigid base or ground.
55m
6m
MAXIMUM DELIVERY HEIGHT
WATER LEVEL
CAUTION:
ALWAYS CARRY OR LIFT THE PUMP BY THE
FRAME TO AVOID DAMAGING THE UNIT.
CAUTION:
THIS PRODUCT IS INTENDED FOR PUMPING
WATER IN A HOME DOMESTIC APPLICATION. DO NOT
USE IT FOR CORROSIVE, ABRASIVE, EXPLOSIVE OR
DANGEROUS LIQUIDS.
2 Ensure the distance from the surface of the water to the pump inlet
does not exceed 6m.
3 Ensure the distance from the pump to the highest point that you
wish to deliver the water does not exceed 55 metres.
Before starting, perform a few simple checks:
WARNING!
ENSURE THE OUTLET FOR THIS PUMP, INCLUDING
ANY HOSES OR PIPES ARE NOT RESTRICTED OR OBSTRUCTED
IN ANY WAY. TAPS, VALVES AND ANY TYPE OF TRIGGER
NOZZLE MUST NEVER BE USED WITH THIS PUMP. FAILURE TO
FOLLOW THESE INSTRUCTIONS MAY RESULT IN PUMP FAILURE
OR SERIOUS INJURY.
