Adjusting the table height
1. Loosen the table support
lock.
Adjusting the table angle
The table can be adjusted up to 45° to the left or right.
1. Loosen the table support
angle bolt (located below
the table) by rotating anti-
clockwise using an 18mm
spanner or shifter (not
supplied).
2. HEIGHT & ANGLE ADJUSTMENTS
3. DEPTH ADJUSTMENTS
ADJUSTMENTS
0
10
20
30
40
50
0
10
20
30
40
50
0
10
20
30
40
50
0
10
20
30
40
50
0
10
20
30
40
50
0
10
20
30
40
50
WARNING!
BEFORE MAKING ANY ADJUSTMENTS,
ENSURE THE DRILL PRESS IS DISCONNECTED
FROM THE MAINS POWER.
CAUTION!
WHEN THE TABLE IS ANGLED/TILTED, ENSURE
THE WORKPIECE IS CLAMPED TO THE TABLE.
Pre-setting the drilling depth
1. Loosen the depth indicator lock nuts by
turning in an anti-clockwise direction.
2. Ensure the drill bit is secure in the
13mm keyed chuck and tightened
correctly. Lower the feed wheel
handles to the desired depth using
the depth scale.
3. Whilst holding the feed wheel handles,
tighten the depth indicator lock nuts until
they touch the metal stop.
4. Lift the feed wheel handles up and then
proceed to operate the drill press.
5. To disable the depth lock loosen the depth indicator lock nuts and
reset to the desired position. Having these in the highest position on
the depth rod will provide maximum drilling capacity.
2. Set the desired table height and
tighten the table support lock to
secure the table in position.
2. Align and set the desired angle.
Tighten the table support angle
bolt by rotating in a clockwise
direction to secure the table in
position.
0
10
20
30
40
50
0
10
20
30
40
50
0
10
20
30
40
50
0
10
20
30
40
50
0
10
20
30
40
50
0
10
20
30
40
50
0
10
20
30
40
50
0
10
20
30
40
50
0
10
20
30
40
50
0
10
20
30
40
50
0
10
20
30
40
50
0
10
20
30
40
50
